With the mobile extraction system vent-medis offers you an ideal additional device
to increase safety in lung ventilation with active aerosols
and quasi gases. The mobile device is easy to handle, easy to operate and requires only little space (footprint 40 x 50 cm).
With this system you can achieve additional safety when using aerosols and quasi gases. The unit sucks in and filters the ambient air around the patient's head. If aerosol / gas escape due to a patient error during exhalation or a sudden cough, it can be sucked off and thus room air contamination can be greatly reduced.
The filter unit in the device is specially designed for technetium graphite particles and contains a powerful dual filter system consisting of a pre-filter and a high-performance ULPA-class HEPA filter.
(ULPA filter = Ultra Low Penetration Air Filter).
The control of the device is equipped with a digital full-text control panel
with speed control, filter monitoring and operating hours counter.
The swivel arm has a pipe diameter of 7.5 cm and a reach of 85 cm. The round, transparent dome hood has a patient-friendly and even recommended diameter of 50 cm.
The housing is made of sturdy sheet steel and runs on smooth-running double castors. It has a wide handle on the top and a large cable holder with combined wall impact protection on the rear side.
Technical data of the filter system:
Flow rate: 390 m3/h
Pressure difference: 4000 Pa
Motor rated power: 240 W
Speed: 8200 rpm.
Nominal voltage: 230 V, 50 Hz
Current consumption: 2.0 A
Dimensions WxDxH: 400 x 500 x 760 mm
Weight: approx. 50 kg